Hydroaccumulators
Epoll
Product code: 6205
maximum capacity of single accumulator: 1000 l
maximum working pressure: 375 bar
Hydac
Product code: 2712
maximum capacity of single accumulator: 250 l
maximum working pressure: 350 bar
Hydac
Product code: 2730
maximum flow rate: 8 l/min
maximum working pressure: 350 bar
tank capacity: 8, 13, 40 l
Hydac
Product code: 2721
DN 6, G3/8
maximum working pressure: 350 bar
maximum flow rate: 30 l/min
Fox
Product code: 4245
capacity: 0.35–50 l
maximum working pressure: 250 bar
Fox
Product code: 4249
capacity: 10–50 l
maximum working pressure: 220 bar
Fox
Product code: 4247
capacity: 9.6–50.6 l
maximum working pressure: 450 bar
Fox
Product code: 4244
capacity: 0.15–3.8 l
maximum working pressure: 250 bar
Fox
Product code: 4243
capacity: 0.05–2.3 l
maximum working pressure: 300 bar
Fox
Product code: 4242
capacity: 0.05–10 l
maximum working pressure: 10 bar
Fox
Product code: 4241
capacity: 0.35–50 l
maximum working pressure: 150 bar
Fox
Product code: 4237
3-way
G3/4, G1 1/4, G2
maximum working pressure: 350 bar
Hydraulic accumulators
Hydraulic accumulators are special containers which allows you to accumulate energy, which is then transferred to the hydraulic system through the fluid stream.
Most often, hydraulic accumulators are used to absorb shock, but they are successfully used to perform work in emergency situations (for example, a disconnected hydraulic pump). It is advisable to install a hydraulic accumulator for hydraulics in those systems where there is an occasional need for an increased flow rate that exceeds the average flow rate of a given hydraulic system.
Hydraulic accumulator classification
High pressure accumulators can be divided into three groups:
- balloon: the rubber bulb in this type acts as a gas and liquid separator. With increasing pressure, it contracts, and the fluid enters the battery. The most common type, is able to accumulate up to 1 thousand liters of liquid. It is possible to replace the rubber bulb with a new one;
- membrane: the most common type. Structurally reminds the previous one, only here a rubber membrane is used. They are used in systems where an instant release of energy is required with a small size of the drive itself. Nitrogen is used as the working gas. The average value of the working pressure is up to 300 bar; it is capable of accumulating up to 10 liters of working fluid;
- piston: the same principle of operation, only the separator — the piston. The seal material on the piston determines the temperature of the fluid. The battery allows you to accumulate more than 3 thousand liters, and issue a pressure of about 1 thousand atmospheres.
"Motorimpex" company offers you to by high-pressure hydraulic accumulators at reasonable prices. We are official partner, so we guarantee certificated products. Each manufacturer, presented on the website, tests their products. You can be sure in safety and reliable work of this system element.