Mounting the Serv-Clip type adapter in the hydraulic system allows you to quickly create control points in places where this is not provided for by the design. Without draining the working fluid, cutting and welding.
In three minutes, the test fitting is installed on a metal pipeline with a diameter from 10 to 42 mm and makes a hole in it for diagnostic and hydraulic system service.
Model Serv-Clip 1 uses for installation of pipeline during the hydraulic system with working pressure operation. Maximum pipe wall thickness — 5 mm.
A punch is screwed in with a 22 mm wrench until the pipe wall is completely pierced with a special needle in the nozzle design. After this required sensor is screwed into the fitting.