Mechanical flow working liquid sensor for diagnostic of hydraulic systems FI 750
Mechanical flow working liquid sensor for diagnostic of hydraulic systems FI 750
It is convenient to install in hazardous areas or in places where there is no possibility of using additional electricity.
Technical characteristics FI 750-180 ABOT:
- Measurement range covered: 2 - 180 l/min,
- Maximum working pressure: 420 bar,
- Relative measurement error: 4% of full scale,
- Connection type: internal thread, G3/4”,
- Dial Diameter: 63mm,
- Options: built-in thermometer.
The flowmeter consists of a sharp through hole and a conical measuring piston. The movement of the piston is directly proportional to the flow rate, and the bore with a sharp edge minimizes the effect of viscosity and contamination particles. The piston is connected by a magnet to a rotating pointer, which shows the flow rate on two scales at once: liters per minute and gallons per minute.
The flow sensor FI 750 can be installed in any position. Not used in circuits in which the flow is reversed. A pressure gauge or pressure measuring point can be installed in the housing.
Direct flow meters manufactured by Webtec FI 750 are designed for continuous monitoring or periodic use during commissioning and maintenance of hydraulic systems. For example, to determine the performance of a hydraulic pump and adjust the directional control valves. Can be used both in mobile and industrial hydraulic systems. And also in lubrication and cooling systems using mineral or synthetic oils.
Our engineers, with whom you are already cooperating, always ready to clarify special prices and answer answer additional questions.
Call and message to order: +38 (057) 713-61-62, +38 (095) 000-30-10, +38 (097) 085-80-80 – Viber, Telegram, m-impex@m-impex.com.ua